We sell new final drives, so take the bias into account and check the numbers yourself. That said, the honest answer is that final drive repair makes sense in a narrow set of cases and loses money in most of the rest. Here is where the line actually sits.
Three situations genuinely favour repair. The first is a leak caught early: the gear oil is still clean, the only fault is a weeping duo-cone seal, and a seal kit plus fresh oil puts the machine back to work for a small fraction of a replacement. The second is an obsolete machine for which no new assembly is manufactured any more, where a rebuild is the only route. The third is a low-hour drive damaged by a single identifiable event, such as a case drain line that was left disconnected, where the rest of the assembly never ran contaminated.
If your drive fits one of those, rebuild it. The rest of this page is about the cases that do not.
Once a bearing or a gear starts shedding material, that debris circulates through the whole housing. The planetary set, the bearing races, the rotating group and the valve plate have all been through the same grit. A rebuild that replaces the obviously broken parts returns the rest to service with their remaining life already spent, which is why so many rebuilt hydraulic motors and rebuilt final drives come back within a year.
A piston motor rebuild lives or dies on the rotating group, which is matched and lapped to microns. Most shops that rebuild hydraulic motors do not remanufacture the cylinder block and valve plate, they reuse them, and the internal leakage that made the motor weak in the first place is still there when it goes back on the machine.
An excavator travel motor rebuild is usually quoted before the housing is opened. The bill after teardown depends on what the shop finds, and by then the machine is already down and there is little room left to negotiate.
A rebuild means removal, shipping to a shop, teardown, waiting on parts, reassembly and refitting. That is commonly one to three weeks. A new unit ships from stock and goes on as soon as it arrives. On a machine earning daily, the difference in downtime often exceeds the difference in parts price on its own.
Rebuild warranties are typically short and hour-limited, and they cover the parts that shop replaced rather than the assembly. A new drive from us carries coverage of up to two years, depending on the item, under our warranty policy.
Take the rebuild quote, add the shipping both ways, add an allowance for what teardown will find, then multiply your day rate by the realistic downtime. The same arithmetic applies when a shop quotes to rebuild a hydraulic motor or a pump drive. Compare that against a new unit shipped from stock with same-day dispatch. On mini excavator final drive rebuilds the two figures are often close, and the new unit wins on risk. On larger machines the rebuild can look cheaper on paper until the downtime is priced in. Our final drive motor replacement cost guide sets out what to compare.
A slow or dead track is not automatically a failed drive. The main pump, the two-speed solenoid, the travel circuit relief and the case drain can all produce the same symptom, and swapping a drive that was never at fault is the most expensive way to find that out. Work through the symptoms of a failing final drive first, and on a Caterpillar track loader follow the codes in the CAT 289D drive motor diagnosis guide. If you want to know which internal part matches which symptom, the breakdown is in final drive motor parts and what wears first.
Whatever killed the old drive is still in the machine. Flush the circuit before fitting, following the hydraulic flush procedure, check that the case drain line is clear and unrestricted, set track tension to specification rather than by eye, and torque the mounting hardware using our bolt torque settings. Then keep the gear oil on schedule using our final drive gear oil change guide.
The final drive motors catalogue lists new assemblies across some 40 machine makes, and anything held in stock normally leaves the same day. Send your model and serial number through the quote form and we will confirm the exact unit before you commit either way.
